It has a max of 4 schedules/programs/egg-timers. Not important for my questions above but just incase: I'm completely green with this automation thing and any advise will be deeply appreciated. How to change settings of the valves for this? It should work like SPA, except the pool drain should be open, not the spa drain. I would like to change the "Spilloway" feature. Pool High? The "pool" circuit function is not available for other circuits.ģ. Is it possible to have iChlor working also with other features e.g. Feature1 - Cleaner / Generic / Feature Section / OFF )I didn't do it it was already set up. AUX3 - Spillway / Generic / Feature Section / OFF (I have an additional question below) AUX2 - Pool High / Generic / Feature Section / OFF AUX1 - Pool light / generic / Feature Section / OFF I used ScreenLogic Config to set up the circuits: (name / function / shown on on with freeze): I would like to have 2 hours at higher speed to clean the pool after we play with the dogs in the pool (to remove all dog hairs). pool high 6am - 7 am (I'm not sure if I set up this circuit properly, iChlor doesn't work with this)Īfter one day it looks like 8 hours at 1500 rpm (220 W) is enough to maintain ~ 3 ppm CL They start normally, however they don't stop when they should.
Using screenLogic2 and ScreenLogic config on my phone I have set up several schedules.
Everything looks good except I have problem to set up schedules. Yesterday new iChlor30, InteliFlo 3HP and ET4 with ScreenLogic2 were installed. Hello, I'm looking for some advice regarding the automation.
0 kommentar(er)
